Manual

Solutions to Common Problems
" :' .....hI I1_ ............II ....... ,_ ' ............ I I _11 :',
•EIectronic control has detected a fault condition. Push CANCEL pad to clear the
display and stop the dispIay from beeping. Reprogram the oven. If a fauIt reoccurs,
record the fauIt number, push the CANCEL pad and contact an authorized servicer.
I I : Lia I
:,ll,I I ll,
• The door was teft open and controls set for self-cleaning cycle. CIose the door and
push both upper and lower oven CANCEL pads.
IIIIIIIIIIIIIIIIIIIIII
• PIace oven rack in center of oven. PIace a Ievet on the oven rack. Contact installing
agent if rack and cabinet cutout flooring are not IeveL
• Kitchen cabinet misalignment may make oven appear to be not level. Be sure
cabinets are square and level. Contact cabinet maker to correct problem.
, .......................
• When the oven is first pIugged in, or when the power supply to the oven has been
interrupted, the dispIay wilIflash. The oven cannot be programmed untit the clock is
set.
• Be sure etectricaI cord is securety c°nnected int° the electrical juncti°n b°x"
• CordipIug is not instalIed and/or connected. Cord is not suppIied with oven. Contact
your dealer, installing agent or authorized servicer.
• Service wiring not complete. Contact your dealer, installing agent or authorized
servicer.
• Power outage. Check house Iights to be sure. Calt your tocat electric company.
• Short in cord/plug. Replace cord/plug.