Manual

Setting Oven Controls
• • • • • • • • • • • • • • • • • • • • • •
The _ or _ pad is used to set the clock. The dock may be set for 12 or 24 hour time
of day operation. The dock has been preset at the factory for the 12 hour operation. When
the range is first plugged in, or when the power supply to the range has been interrupted,
the timer in the display will flash with "PF" (power failure, See Figure 1). Note: The dock
cannot be set when the oven is on.
When PF appears in the display, press _ or (_9" No sound will be heard, but after 10
seconds a beep wiI( sounds and PF wilI disappear.
1.
Figure 1 2.
To setthe clock(example belowfor 1:30):
Press O or _. "CLO" will appear in the display (Figure 2).
Press Q Q Q pads to set the time of day to 1:30 (Figure 3). "CLO" will
appear in the dispIay. Press @ or _). "CLO" will disappear and the clock
will start (Figure 4).
Figure 2
Figure 3
Figure 4
Figure 5
Changing between12 or 24 hourtime of day display:
Press and hold (_ or _(_ for 8 seconds (Figure 3). While holdingthe pad
1.
down the current time of day wiII remain and "CLO" wilI disappear from the
dispIay (Figure 4). CONTINUE holding the pad until a beep is heard.
2. The display wiIl show either "12Hr" (Figure 5) or "24Hr" (Fig.6).
3. Press O or C_ to switch between the 12 and 24 hour time of
day display.
The display wiI( show either "12Hr" (Figure 5) or "24Hr" (Figure 6).
or _ to accept the change or press _) or _ to reiect
4.
Press the
change.
5. Reset the correct time as described in To set the Clock above. Please note
that if the 24 hour time of day mode was chosen, the clock will now display
time from 0:00 through 23:59 hours.
Figure 6