Manual

Operation
iiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiii
Temp Ter.p System
Minus On/Off Plus Lock Status
keypad keypad keypad Display Area keypad indicators
Electronic Control Display
Starting your appliance:
Plug the appliance power cord into a 115
volt wall outlet. Your appliance is shipped
from the factory in the "On" position and
will begin start-up of cooling as soon as
power is supplied. If the appliance does
not start, confirm that the wall outlet has
power, and that the control is in the "On"
position, (See "Turning your appliance On
and Off").
The control display is covered with a clear
plastic film. This film may be removed by
carefully lifting the film at a corner.
On initialpower up, the control display will
indicate a "Power Failure"alarm. This is
a normal condition as the appliance was
powered-up at the factory for quality inspection
and then removed from power.A momentary
press ofthe "On/Off" keypad will reset this
alarm condition. (SeeAlarms section).
/
Sleep mode:
If no keypads are pressed for 60 seconds,
the display will enter sleep mode to
conserve power. The control panel will
go dark with the exception of the system
iiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiii
To wake the display press any keypad. A iiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiii
confirm tone will sound, and the current iiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiii
storagecompartmenttemperaturewill be iiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiii
disp,ayed iiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiii
iiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiii
The sleep mode can be disabled if you
prefer to have the display on continuously.
Press and hold the "Lock" keypad until the
display goes past "Loc" and reads "nSL"
To enable the sleep mode, repeat the iiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiii
instruction, again going past "hoc" until the iiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiii
displayreads "SLP". iiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiii
TumingyourapplianceONandOFF: iiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiii
If the appliance is "On", (and out of sleep iiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiii
mode) thetemperaturewillbeshownin iiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiii
the display area of the control. To turn the iiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiii
appliance "Off", pressand holdthe iiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiii
"On/Off" keypad for four seconds. "OFF" iiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiii
willnowbedisplayedonthecontrol, iiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiii
iiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiii
iiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiii
iiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiii
iiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiii_
status "OK" indicator which will remain
enabled. Alarm conditions will wake the
display, (See Alarms section). To turn the appliance "On", press and hold
the "On/Off" keypad for four seconds.
To make the following changes to the
control settings (turning the appliance ON/
OFF, adjusting the temperature, changing
the interior lights, and activating vacation
mode), the control must be awake.
iiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiii