Installation guide

Installation 17
CONNECTING THE PLUMBING (E24CM76GSS)
[] [] [] [] II [] [] II [] [] [] [] [] [] [] [] [] [] [] !1 I! []
Z WARNING
• To prevent damage to the coffee system due to hard water, prior to
installation, check the water hardness for the building where you will
be installing the coffee maker. See page 12
• To avoid leaks, do not overtighten fittings.
Insert the 314" gasket into the 314" fitting on the water supply hose. Make sure
it is properly seated.
Connect the 3/4" end of the hose to the water inlet on the back of the coffee
maker.
Insert the 1/4" gasket into the 1/4" fitting on the water supply hose. Make sure
it is properly seated.
Connect the other end (1/4") of the hose to the water supply.
Backof Coffee
Maker
Power Cord
Waterlnlet
Gasket
Water Supply
Hose