Installation & Operating Instructions CS 52 Type C...
Introduction Thank you for choosing the Electrolux Wine Cellar. Please read the following instructions carefully before installing your new wine cellar. We trust you will be completely satisfied with your purchase. The wine cellar must be installed and used according to these instructions in order for it to operate correctly and economically.
2. Release the button. Press the UP/DOWN arrow buttons to set the temperature. The new value is saved automatically after 6 seconds. Electrical connection It is essential that the electrical installation is carried out correctly, taking into account all relevant regulations and codes of practice. Your wine cellar will operate on a mono-phased alternating current. Please check that the voltage shown on the data plate corresponds to your power supply. Maintenance ! WARNING The wine cellar must be earthed.
Shelf supports and shelf locks The wine cellar is equipped with 5 shelves and 20 shelf supports. The shelves are at delivery fixed to the side of the wine cellar with a shelf lock. These can easily be removed with a screwdriver.
Appendix a - Electric diagram - -
Appendix B - mounting the handle stainless steel door 1 q Remove the door gasket behind the two holes adapted for the handle. Start in the upper corner and gently pull out the gasket from the slot. Continue down and pass the two holes. 2 q From the inside of the door, put the two attached screws (M4x60) first through the door frame (1), then through the distance bar (2) and then tap the screw into the threads in the vertical handle bar (3).
