Owner's Guide

12
Removing the Doors
Installing Freezer Drawer
1 With lower slides pulled out, hang drawer onto
slide brackets ensuring pins on each side are
fully inserted into slots on each side.
6 Tighten four drawer screws.
7 Recheck gasket seal.
8 Install the toe grille by fitting into place.
2 Reinstall four drawer screws (two per side),
tighten down, and close drawer (C).
Push
Against
Freezer
Drawer
Grab Drawer
At Center
From
Both Sides
Then
Pull Drawer
Out
A B
Assembly
Pin
Slot
Cabinet
Fully Extend
Drawer Slides
Install Hex
Head
Drawer
Screws
3 Check gasket seal around top, bottom, and sides
of freezer drawer.
4 If gasket is not sealed, open drawer and slightly
loosen four drawer screws (two on each side) to
allow drawer to rotate.
5 Close drawer and recheck the seal on the gasket
(A). Open the drawer grabbing by the sides in the
center (B). Be careful not to rotate the drawer.