I N F O OPERATING AND ASSEMBLY INSTRUCTIONS GLASS CERAMIC HOB CC 3085 Electrolux GB
DEAR CUSTOMER We congratulate you on choosing a ceramic hob of ELECTROLUX. Thus you chose quality, innovation and durability. These operating and assembly instructions will allow you to become acquainted with the appliance and to do everything within its possibilities.
CONTENT Please note in particular ......................................... 4 Unpacking and control ........................................... 5 Description of appliances ...................................... 5 Before the first use ................................................ 5 Technical data ....................................................... 6 Operating instructions ............................................ 6 Cooking equipment ................................................ 7 Maintenance ...
PLEASE NOTE IN PARTICULAR Before using the hob for the first time, read the operating and assembly instructions carefully. You protect yourself and avoid damage of your appliance. The appliance must be installed by a qualified electrician. Use the hob only upon its installation. This protects you from touching electric parts. Repairs of electric appliances must be undertaken by qualified electricians only. Improper repairs can cause serious harm and danger for the user.
UNPACKING AND CONTROL Please examine the appliance for any damage sustained during transportation! If the appliance is damaged please immediately inform the forwarding company before the appliance is connected. The packing material should be disposed properly.
TECHNICAL DATA Hob dimensions length width height 795 mm 515 mm 43 mm Cutout dimensions length width radius 780 mm 500 mm 55 mm Rating plates Typ Instr. No. Voltage Total power 220/380 V ~ 50 Hz Mod. CC 3085 Prod.No. 941 592 674 Ser.No. 7.02 kW 230 V ~ 50 Hz SWISS MADE 7.02 kW Typ Instr. No. Mod. CC 3085 Prod.No. 941 592 675 Ser.No. 7.02 kW 400 V ~ 50 Hz SWISS MADE OPERATING INSTRUCTIONS Cooking zones The cooking zones are clearly marked on the ceramic surface.
OPERATING INSTRUCTIONS Warming zone The warming zone will be turned on and off by the touch control unit located on the ceramic surface in front of the warming zone. By touching the corresponding field, "1" resp. "0", it will be switched on resp. turned off. Residual heat indicator Each cooking zone is related to one indicator. The warning lamp lights up when the surface of the corresponding cooking zone reaches a temperature which could cause burning.
MAINTENANCE The maintenance remains the same for glass and ceramic hobs. Never use aggressive detergents or scouring powder and sponges with abrasive surfaces. Cleaning after each use Slight, not burnt soiling has to be wiped off with a damp cloth without using detergents. The use of detergents may lead to discolouring. These heavy stains can not be wiped off easily by the first attempt and sometimes not even with a special detergent. Burnt soiling has to be removed with a scraper.
INSTALLATION 1 . Cut out worktop to prescribed measurements (fig.1) or templates (saw exactly along the scribing) and fasten the fixing springs in the cutout with the enclosed screws. Position the springs according to the enclosed template. The upper part of the ressort is the spacing stop. fig.1 2 . The working plate must be clean. Check seal for perfect fit and overall cover. Lower the ceramic hob into the cut-out. Press firmly on one side then on the opposite side to snap-in the unit (fig.2).
PROBLEM DETECTION AND REPAIR DEVICE Repairs on electrical appliances must be undertaken by qualified electricians only. Improper repairs can cause serious harm and danger for users. The appliance is only disconnected from the mains when the fuse is turned off or the mains connection is interrupted You are able to clear the following defects: When the cooking zone does not heat up after you switched it on? =>Make sure that the fuse is turned on.
Electrolux 08.
