Vied come to the family of Electrolyte Users. You are now the proud owner date dishwasher that will rake the repetitive chore of washing up so much easier. This book not only tells you how to operate your new Electrolyte dishwasher but includes instructions on how to install It properly, Please read it through carefully foreseeing your new machine.
Installation In order that your new dishwasher will operate correctly and give you the best possible results it must be installed in accordance with the following instructions.
Recommended Drainage Connections. You must abide by any Local Authority Bylaws regarding drainage and i you live ir a Mull Store building we strongly recommend that you seek expert advice as special arrangements may be required. Water and drain connections Outlet Hose and Drain Alternative methods of discharging to the drains arg s follows: 1. Directly info a sink by hanging the hooked end of the has over the edge of the soak, making sure that the sink plug has first been removed.
infer water connection The dishwasher may he connected either to hot or cold water supply but not both 1T MUST NEVER BE CONNECTED TO MIXER TAR The pressure of the water supply should be between 80 KN/m? ~ 1000 kn? (12 145 b/ in?} and the temperature should not exceed FOP 1 you connect your dishwasher {0 the hot water supply you must remember that all filch will be with hot water and this could mean a total hot water consumption of 28 liters (6 garfish.
Getting to know your Dishwasher This section is designed to help you become familiar with the various features of your new dishwasher. Indicator fight ¢ This laminates the timer control dial and its up when the dishwasher is operating. At the end of the programmer this light goes out.
salts Vised the float will gradually sink from view When the float has nearly disappeared the container should be refiled with all, this will be after 15-30 washes. For type and quantity of salt see “Preparing your Dishwasher” Water softener adjuster 1 As the hardness of water varies throughout the country the amount of regeneration the softener requires will also vary.
Preparing your Dishwasher Before using your new dishwasher for the first tine you must (A) Fil the rinse-aid container and adjust the dispenser; (8 Fill the salt container for the water softener and adjust the softener. Filing the rinse-aid container Isis preferable to use rinse-aid and detergent of the same make so that they are compatible with one another, Electrocute have tested and recommend ‘Sun’ rinse-aid and detergent, free samples of which are supplied with every machine.
Remember the rinse raid container should always be refilled before it is completely empty. Filling the sat container for the water softener Remove the lower dish rack to give access o the salt container filer cap and unscrew the cap. Having removed the cap, place a funnel over the opening and pour in about water softener granular or regeneration salt. Available farm larger hardware stores or builders merchants.
1. Scrape plates clean of large pieces of waste food, bones, etc. 2. Loading, The dish racks should be pulled forward gently on their wheels to make the racks more accessible for lading. Typical loading for sate of the racks are shown in the illustrations on Page 7. The upper dish rack is for cups, Saucers, glassware, small plates and bowls, ete. Cups, glasses and howls should be placed upside down. The lower dish rack is for large plates, dishes. saucepans, ete.
8. After the wash When the washing programmer has finished, the machine will stop and the light will go out. You should then switch off the machine, and also turn off the water supply stopcock, Bo not turn off the water before the programmer has finished, as water is needed for the regeneration of the water softener which takes place during the drying cycle. finally, remember fo inspect the filters occasionally and, necessary, rinse them under 21ap.
Useful Information Generally speaking, crockery and cutlery which can normally be washed by hand can also be washed in the machine, although pans, stapler dishes, etc., which have food burnt on, cannot always be expected to be completely clean, Some materials are not suitable for machine washing, or require special treatment, therefore, 1o avoid any disappointment, we suggest the following information is carefully studied.
Whatnot and when i the event of your machine developing a fault, you should quickly run through this:check list before calling your local Electrolyte Service Reception Unit. if your wash is not satisfactory. 1. Check that the crockery or cutlery has been properly loaded. 2. Check that the spray arms, or holes in the arms, have not become obstructed or blocked. 3. Check that the fitter is clean. 4. Check that the programmer selected was the correct one. 5. Check that the correct amount of detergent was used.
