Welcome to the family of Electrolyte Users. You are now the proud owner date dishwasher that will make the repetitive chore of washing up so much easier. This book not only tells you how to operate our new Electrolyte dishwasher but induces instructions on how to install i property. Please read it through carefully before using your new machine.
Installation frn order that your new dishwasher will operate correctly and give you the best possible results it must be installed in accordance with the following instructions. Any local regulations concerning connections to the electricity and water supplies and drainage must also be complied with. Location Two dishwasher can be placed in any suitable don providing the water, drain and electrical connections are accessible.
Recommended Drainage Connections You must abide by any Local Authority Bylaws. regarding drainage and f you five in a Multi Store building we strongly recommend that you seek expert advice as special arrangements may. be required. Water and drain connections Q Outlet Hose and Drain Alternative methods of discharging to the drains are as follows: 1. Directly into a sink ~ by hanging the hooked end of the hose over the edge of the sink, making sure that the sink plug has first been removed.
Intel water connection The dishwasher may be connected either to hot or cold water supply but ngt both. IT MUST NEVER BE CONNECTED TO A MIXER TAP. The pressure of the water supply should be between 80 kn? 1000 kN {12 145 1b/ in?) and the temperature should not exceed 70°C (130°6). #yoy connect your dishwasher 1o the hot water Jly you must remember that all fills will be with hoot water and this could mean a total hot water consumption of 49 fires {10% galls). The water inlet hose has a %" BS.
Getting to know your Dishwasher This section is designed to help you become familiar with the various features of your new dishwasher. indicator fight 1 This illuminates the mire control dial and its up when the dishwasher is operating, At the end of the programmer this light goes out. Programmer selector knob and display 2 Turn the knob 1o select any.of the basic.
Rinse-aid level indicator 10 This shows when the reservoir requires filling. The indicator is a small window which will appear dark all over when the container is full. However a3 the container implies the dark area will gradually diminish, Water softener 11 To prevent a build up of white deposits on dishes.
therefore that the holes skeptical by regularly removing the arms farm the wash chamber and rinsing them under a tap. The upper spray arm 16 s attached to the upper dish rack and after reproving the rack from the machine & can be removed simply by undoing the plastic regaining nut.
Remember the rinse-aid container should always be refilled before it is completely empty. Filling the salt container for the water softener Remove the lower dish rack to give access to the salt container filler cap and unscrew the cap. Having removed the cap, place a dunned over the opening and pour in about water softener granular or regeneration salt. Available from larger hardware stores or builders merchants. For convenience we recommend SUN Sat Tablets, a sample of which is supplied with the machine.
Using your Dishwasher 1. Serape plates clean of large pieces of waste food, bones, ete. 2. Loading, The dish racks should be pulled forward gently on their wheels to make the racks more accessible for loading. Typical loading for each of the racks are shown in the illustrations on Page 7. The upper dish rack is for cups, saucers, glassware, small plates and crowds, eic, Cups, sizes and bowls should be placed upside 3.
8. After the wash When the washing programmer has finished, the machine will stop and the light will go out. You should then switch off the machine, and also turn off the water supply stopcock, Da not turn off the water before the programmer has finished, as water is needed for the regeneration of the water softener which takes place during the drying cycle. Finally, remember to inspect the filters. regionally and, if necessary, tines them under 4.
Useful Information Generally speaking, crockery and cutlery which can normally be washed by hand can also be washed in the machine, although pans, casserole dishes, etc., which have food burnt an, cannot always be expected to be completely clean. Some materials are not suitable for machine washing, or require special treatment, therefore, 1o avoid any disappointment, we suggest the following information is carefully studied.
What to do and when in the event of your machine developing a fault, you should quickly run through this check fist before calling your focal Electrolyte Service Reception Unit, 1 your wash is not satisfactory. 1. Check that the crockery or cutlery has been properly loaded, 2. Check that the spray arms, or holes in the arms, have not become obstructed or blocked, heck that the filter is clean. 4. Check that the programmer selected was the correct one. 5. Check that the correct amount of detergent was used.
