Service manual

Failure code chart

Failure code Fault condition Action

E4A The drying time has exceeded program Press Pause Cancel and SELECT buttons for

time for cycle. 6 seconds to exit test modes. Position cycle

selector to NORMAL, temperature selector to

HIGH HEAT and touch START. Check for any

thing that would extend dry times such as: no

heat, restricted vent, blower fan blade broken

or loose, dryer installed in closet with solid door,

or bad connection in moisture sensor bar cir

cuit or dirty bars. If dryer operates normally but

code returns, replace electronic control.

E 5B No heat. Refer to flow chart dryer does not heat.

E 68 One of the keys (buttons) is Enter function test mode and perform key

stuck closed (active). (button) test to determine which button is at

fault. Carefully free the and perform the test

again. If button is free but the key struck code

still exists, replace electronic control.

E 8C High limit thermostat has trip to many times Check for blocked lint filter, blocked exhaust,

in a certain amount of time. air leaks around air duct, broken blower fan

blades, worn or loose drum seals, dryer installed

in closet with solid doors or door seal not

correctly seated.

E AF Microcontroller has been reset Clear code, exit mode and start dryer. If

by Watchdog timer. problem persists, replace electronic control.