Service manual

94
Removing the heating element:
Note: The heating element is held and sealed to
the tub by compressing the rubber gasket
between the two metal mounting plates of
the element. When the nut in the center
of the element mounting plate is tightened,
the two metal plates are drawn together
compressing the rubber gasket.
1. Disconnect the washer from electrical supply and
remove the rear access panel.
2. Disconnect the wires from the heating element and
the drum water NTC.
3. Loosen the compression nut and pull the heater
assembly out of the drum.
Removing the drum water NTC:
1. Disconnect the washer from electrical supply and
remove the rear access panel.
2. Disconnect the wires from the drum water NTC.
3. Loosen the compressionnut and pullthedrum water
NTC out of the heater assembly.
Removing the air bell:
1. Disconnect the washer from the electrical supply
and remove the front panel.
2. Remove the (2) hoses, one from each end.
Metal plates
Nut
Rubber
gasket