A 602K Operation instructions 207.5081.
Fig.
Dear customer, please read the instruction book and all additional information before using the appliance. It is most important that they should be retained with the appliance for future reference! 1. Warnings and directions These warnings are provided in the interest of safety. You must read them carefully before installing or using the appliance! This product is designed to be operated by adults. Children shouId not be allowed to tamper with the controls or play with the product.
3. Storage of gas cylinders Liquid gas cylinders should never be stored in unventilated areas or below ground (funnel-shaped holes). Avoid direct sunlight. The gas cylinder should not be exposed to temperatures in excess of 50°C. 4. Installation To be installed horizontally on a smooth, firm or any other appropriate surface. If necessary, adjust/align using a spirit level or a water-filled vessel. There should be a distance of at least 10cm between the back of the unit and any other object (wall).
Turn thermostat knob (A) anticlockwise to position '0'=off (a slight resistance will be felt just before this position). Pull out mains plug. 7. D/C operation Do not use any additional form of energy (mains/gas). A safety fuse must be installed in the electricity supply between battery and refrigerator in a duct. 12 V: maximum 15 amps; 24 V: maximum 7.5 amps, Cable cross section 2.5 mm2 4.0mm2 6.0 mm2 until until until max. cable lengths 12V 24 V 2.5 m 5m 4.0m 8m 6.
The refrigerator is equipped for a specific gas-pressure, corresponding to the standard pressure of the country in which it is sold. The rating-plate states the pressure which is correct. It is important that a non adjustable pressure-regulator is used to reduce the pressure in the gas cylinder to the operating pressure specified on the rating-plate, no other pressure may be used.
4. After approximately 10 seconds press knob (E) several times. (This could take longer than 10 seconds if the unit has been out of operation for a prolonged period or after replacing the gas cylinder. Cause: air in the pipes.) After ignition, hold down knob (B) for a further 20-30 seconds before releasing. The flame can be controlled by aperture (C). 5. Should no ignition occur, repeat the ignition process after 1 minute. 6.
To avoid any unpleasant smells forming in the cooler, the lid should be left slightly open. 15. Measures after prolonged periods of disuse Should the refrigerator not function correctly after being switched on, place the unit upside down WITHOUT ANY CONNECTING POWER SUPPLY. After a few minutes return the refrigerator to its correct position and switch on again. Should the unit still not function correctly, repeat the process several times. 16.
18.
19. Technical Data Gas operation: butane (propane) Rated thermal loading: Min. thermal loading: Connected load, gas: Connection pressure: Categorie: Climat class: Electric operation: 220 V - 240 V (mains) 50 Hz: 12 V/24 V (car battery): Capacity: Refrigerant: 188 W (192W) 95 W (98W) 13,6 g/h (13,7 g/h) 28-30/37 mbar I3+ N 110W 110 W 54 Ltr. 0,18 kg. NH3 + H2O The appliance does not contain any CFCs/HCFCs. Sodium chromate is used for corrosion protection (less than 2 weight % of the coolant). 20.
Joint Fig 2 Joints Fig 3 11
Printed by Xerox Hungary Ltd. Rev.: 2003. 11. 12.
