Installation Instructions Dishwasher External Blower Assembly for Electrolux Retractable Ventilation Systems E30DD75ESS E36DD75ESS E46DD75ESS E48DD75ESS 5995433678
Safety IMPORTANT SAFETY INSTRUCTIONS Safety Precautions Do not attempt to install or operate your unit until you have read the safety precautions in this manual. Safety items throughout this manual are labeled with a Warning or Caution based on the risk type. Definitions This is the safety alert symbol. It is used to alert you to potential personal injury hazards. Obey all safety messages that follow this symbol to avoid possible injury or death.
Safety SAFETY PRECAUTIONS ! WARNING • To reduce the risk of fire, electric shock, or injury to persons, observe the following: a) Installation work and electrical wiring must be done by qualified person(s) in accordance with all applicable codes and standards, including fire-rated construction. b) Sufficient air is needed for proper combustion and exhausting of gases through the flue (chimney) of fuel burning equipment to prevent back drafting.
Safety SAFETY PRECAUTIONS ! WARNING • To reduce the risk of a range top grease fire: a) Never leave surface units unattended at high settings. Boilovers cause smoking and greasy spillovers that may ignite. Heat oils slowly on low or medium settings. b) Always turn hood ON when cooking at high heat or when flambeing food (i.e. Crepes Suzette, Cherries Jubilee, Peppercorn Beef Flambe’). c) Clean ventilating fans frequently. Grease should not be allowed to accumulate on fan or filter.
Safety SAFETY PRECAUTIONS ! CA UTION CAUTION • For general ventilating use only. Do not use to exhaust hazardous or explosive materials and vapors. • To reduce risk of fire and to properly exhaust air, be sure to duct air outside – Do not vent exhaust air into spaces within walls or ceilings or into attics, crawl spaces or garages. • This blower assembly is approved for use with the following Electrolux retractable ventilation systems: E30DD75ESS, E36DD75ESS, E46DD75ESS and E48DD75ESS only.
Finding Information READ AND SAVE THESE INSTRUCTIONS Attach your sales receipt to this page for future reference. NO TE NOTE Installer: Leave instructions with owner. Owner: Read your Retractable Ventilation System Use & Care Manual. It contains important safety information for operating this appliance. It also has many suggestions for getting the best results from your retractable ventilation system. Read all instructions before installing the retractable vent.
Finding Information TABLE OF CONTENTS Safety ................................................................... 2 Important Safety Instructions .............................. 2 Safety Precautions ............................................. 3 Finding Information ........................................... 6 Please Read And Save This Guide ................... 6 Questions .......................................................... 6 Table of Contents ...............................................
Planning for Installation INSTALLATION PLANNING A qualified technician must complete the installation of this appliance. Carefully check the location where the remote blower is to be installed. The remote blower should be placed for convenient access. Make certain that electrical power can be provided in the selected location. Plan the installation so that all minimum clearances are met or exceeded. Dimensions shown provide minimum clearances, unless otherwise noted.
Planning for Installation Blower Overall Dimensions Model No. Overall Chassis Width Overall Chassis Height 5304444802 26” (660mm) 9 9/16” (243mm) Overall Chassis Length 33 1/2” (851mm) Duct Diameter 10” (254mm) Blower Specifications Model No. 5304444802 Electrical Supply Requirements Maximum Duct Length Refer to Max. 60 Ventilator Equivalent Specifications Straight Feet Total Connected Load Fan Rating* Approx. Shipping Weight 0.3kW (3A) 1600 CFM 55 lbs.
Planning for Installation NO TE NOTE The blower must be sealed between the roof or wall and the underside of the flange with mastic to prevent leaks. For installation on a flat roof, or a roof with a pitch of less than 2:12, install the blower on a curb as shown below. Position the curb on flat roofs so that the discharge (low) end points away from the prevailing wind.
Planning for Installation 11 Blower Roof Installation Side View Blower Air Discharge 45° Adjustable Elbow 3 1/4" x 10" to Round Transistion Cooktop AIR 3 1/4" x 10" 90° Elbow 3 1/4" x 10" 90° Elbow Figure 6
Making the Electrical Connection ELECTRICAL CONNECTION ! WARNING Ensure that the power supply is disconnected before proceeding. Verify that the power supply matches the ratings found on the appliance data plate before proceeding. The complete appliance must be properly grounded at all times when electrical power is applied. Do not ground the appliance with the neutral (white) house supply wire. A separate ground wire must be utilized.
Installing the Blower BLOWER INSTALLATION Mount the blower to the wall or roof using screws, through mounting trim flange. Wiring of Retractable Ventilation System (E30DD75ESS, E36DD75ESS, E46DD75ESS and E48DD75ESS) Verifying Proper Operation 1 2 3 Temporarily re-install the remote blower cover, using 2 screws per side). Turn on the power supply at the circuit breaker. Refer to the Retractable Vent Installation Instructions for further instructions on verifying the proper operation.
1-877-4Electrolux www.electroluxusa.com www.electroluxca.
