Owner's Guide

29
Setting Microwave Controls
More or less time adjustment
Should you discover that you like any of the Sensor
Modes, Auto Cook, Quick Settings, Auto Reheat or
Auto Defrost slightly more done, touch the power
level + pad after touching your choice of pads or
before touching START pad. The display will show
MORE.
Should you discover that you like any of the Sensor
Modes, Auto Cooks, Quick Settings, Auto Reheat
or Auto Defrost slightly less done, touch the power
level - pad after touching your choice of pads or
before touching START pad. The display will show
LESS.
Quick Start
quick start is a short-cut method to set time for 1-9
minutes at power level 100.
• Suppose you want to heat a cup of soup for
two minutes.
Example
Step Press
Press number 2 pad and
wait for 4 seconds.
The oven will start after 5 seconds and will signal
then turn off automatically when finished.
Add 30 Seconds
add 30 seconds provides a convenient way to extend
cooking time by 30 seconds while the oven timer is
counting down. It will add 30 seconds to the time
shown each time the pad is touched.
This pad may also be used as a quick start for
30 seconds of cooking. No need to touch START,
the oven will start immediately.
Help Guide
Most setting has a cooking hint. If you wish to check,
touch help guide whenever the pad is lighted in
the Interactive Display for these and other manual
operation hints.
Multi Stage cooking
Your oven can be programmed for up to 3 automatic
cooking sequences, switching from one power level
setting to another automatically.
Sometimes cooking directions tell you to start on one
power level and then change to a different power
level. Your oven can do this automatically.
• Suppose you want to cook roast beef for 5 minutes
at 100% and then continue to cook for 30 minutes
at 50%.
Example
Step Press
1. Press MICRO OVEN.
2. Press multi stage.
3. Enter cooking time for first
stage.
4. Press power level + to get
to 100.
5. Press START to confi rm
fi rst stage.
6. Enter cooking time for
second stage.
7. Press power level + or -
until you get to 50.
8. Press START to confi rm
second stage.
9. Press START a third time
to confi rm that you do not
want a third stage*.
* You can program a third stage at this step.