Owner's Guide

8
Operating Instructions
S t a t u s w i n d o w
That STATUS window displays codes typically seen
during normal operation or programming of the
dishwasher. The STATUS window indicates the
following activity:
D i s p l ay o n f l o o r
The display on fl oor indicates the following
activities:
The cycle duration remaining
time.
Remaining time of Delay
start
End of cycle
Error codes
1HR-24HR - Indicates
number of delay start
hours for selected
cycle.
CLOSE DOOR -
Flashes once the
program has been
entered and the START
pad is pressed. It also
fl ashes if the door is
opened during a wash
cycle. Close the door
to begin or continue the
wash cycle.
Child Lock is
activated.
MIN - The cycle duration
or the remaining time.
L1 - L4 - Level of Rinse
Aid Dosage.
LOW RINSE - Refi ll
Rinse Aid
CLEAN - End of Cycle.
E r ro r C o d e s
Displayed
Error Code*
Problem Solution
i10
A low fi ll has been detected.
Look for a pinched water supply line, or water shutoff is
not completely opened.
i20;
i40;
iF0
Clogged fi lters or a restricted
drain line has been detected.
Check and clean both fi lters and sump area and check
for a pinched or blocked drain hose. If the drain line is
attached to a disposer, check that the knockout plug
has been removed.
i30
A leak or overfl ow of water
has been detected in the
bottom pan.
Look for loose connections at the water inlet valve and
ensure the unit is properly leveled.
i50
A problem has been
detected with the drain or
wash motor.
Pressing the cancel button or turning power off at the
breaker for 5 min. should clear this error code and
the unit can be restarted.
If this does not resolve the problem, service
will need to be called.
i60
A problem has been
detected with the water
heating system.
iC0
A problem has been
detected with the electronic
control system.
*In all Error Code instances, if Pressing the cancel button or turning power off at the breaker for 5 min.
does not resolve the problem, contact the Electrolux Customer Care Center at 1-877-435-3287.