Wiring diagram
SERVICE DATA SHEET
P/N EIDW5705
Electronic Series
Color Code
BK...................... Black
BU........................ Blue
PK.........................Pink
RD..........................Red
WH/RD.........White/Red
RD-YE........Red/Yellow
VT.......................Violet
OR....................Orange
GR......................Green
W........................White
Wiring Diagram
Display Codes (LED)Display Codes (Readout)
To start
To delay start
Press START/CANCEL pad. Close and latch door.
Press DELAY START pad to select desired
delay time. Close and latch door.
To select a new
cycle or option
Press desired cycle and/or option pad. The indicator lights
will change. Press START/CANCEL within 15
seconds to begin cycle.
To cancel cycle
Press START/CANCEL. Dishwasher will drain for 60
seconds, then shut off.
For controls
lock . . . . . . . . . . .
Press and hold the AIR DRY pad for 3 seconds.
To unlock, press and hold the AIR pad for 3 seconds.DRY
CLEAN
OPTION LED's Flashing
----------------- Shows completion of cycle. Indicator light will go off 30 seconds after door
is opened.
-- HI-TEMP WASH and AIR DRY/ LED's flashing indicates power failure
has occurred. Press START/CANCEL pad and reselect desired options and
cycle.
LOW RINSE
SANITIZE
----------- The liquid rinse agent is low. Light will switch off after 5 complete
wash cycles or dispenser is filled.
--------------- The SANITIZED criteria has been met. Indicator light will go off 30 seconds
after door is opened.
This information is intended for use by
persons having electrical and mechanical
training and a level of knowledge of these
subjects generally considered acceptable in
the appliance repair trade. Electrolux Home
Products North America cannot be
responsible, nor assume any liability, for
injury or damage of any kind arising from
the use of this Service Data Sheet.
Operation
LO.
PF
Cd
'01-24'
.........Low liquid in the rinse aid dispenser
..........A power failure has occurred
..........Close the door
....Hour(s) delay before start
The water/service test is a
Special function initiated
from the power failure
mode or idle mode.
While in power failure
or idle mode -
simultaneously press the
AIR DRY and START/CANCEL
pads for 1 1/2 seconds.
The dishwasher will then
step through the test
cycle per the chart.
Pushing the START/CANCEL
pad will advance the
dishwasher to the next step.
Water/Service Test
(Some models)
Cycle Selection Options