Installation Instructions

raise

lower

Leveling your washer

Excessive noise and vibration can be prevented by properly

leveling the washer.

1 For free standing installation and with the washer within

4 feet (1 m) of its final location, place a level on top of

the washer.

2 Use adjustable pliers to adjust the leveling legs so the

washer is level front-to-rear and side-to-side, and stable

corner-to-corner.

3 Press down on alternate corners and sides and feel for

the slightest movement. Adjust the appropriate leg(s)

so the washer sits solidly on the floor on ALL four legs.

Keep the leveling leg extension at a minimum for best

performance of the washer.

Connecting inlet water

HOT

COLD

NOTE

For pedestal installations, see additional installation

instructions included with the pedestal.

NOTE

Hoses are not included with washer purchase. See

“Accessories” section for various inlet hose kits to fit your

specific installation.

1 Run some water from the hot and cold faucets to flush

the water lines and remove particles that might clog the

water valve screens and to determine which faucet is

hot and which is cold supply.

2 Connect the HOT inlet hose to the HOT inlet connection

on the washer and the COLD inlet hose to the COLD

inlet connection on the washer. Tighten by hand until

snug. Then tighten each supply connection another 2/3

turn with pliers. Do not cross thread or over-tighten

these connections.

3 Connect the HOT inlet hose to the HOT water supply

and the COLD inlet hose to the COLD water supply.

Tighten by hand until snug. Then tighten each supply

connection another 2/3 turn with pliers. Do not bend,

kink or pinch water inlet hoses.

4 Turn on the water and check for leaks.

RUBBER WASHERS

MUST BE PRESENT

USE ONLY

NEW HOSES