Complete Owner's Guide

Setting Oven Controls 33
Setting Delayed Clean
You may wish to set the oven to perform a clean at a later time
(up to 12 hours later). The end time key will determine when the
cleaning will stop.
IMPORTANT! If you want to set a delayed clean to end
between 12 and 24 hours, use the user pref key to set the 12hr
energy saving mode (ES) to Off and also set the clock (CLO) to
the 24 hr mode.
The end time must be set far enough from the real time to allow
for the type of clean cycle you select, whether 2, 3, or 4 hours.
Remember to add 30 to 40 additional minutes of cooling time
before using the oven for cooking.
In the example below, the clean will start at 4:00 o’clock. The
number of hours before 4:00 o’clock will be the delay time
before the clean begins.
Setting for a heavy (4 hour) clean cycle to end at 8:00
o’clock:
To avoid possible burns use caution opening the oven door after
the clean cycle is finished. The oven may still be very hot. Stand
to the side of the oven when opening the door to allow hot air to
escape.
1. Be sure the clock is set with the correct time of day. In
this example the time of day should be earlier than
4:00 o’clock. Remove all oven racks. Be sure the oven
door is completely closed.
2. Press clean - heavy (4hr).
3. Press cook options.
4. Press end time.
5. Enter 8 0 0 using the numeric keys.
800
6. Press START.
7. The oven door will begin to lock and CLn will show in the
display. Once locked, the oven will display the time
remaining until clean begins. When the clean cycle
begins, the display will show the time remaining in the
clean cycle.
Press CANCEL at any time to stop clean