Datasheet

Revision date: 10/03/2020 Revision: 1.2
Polyurethane Resin UR5634, Part B
Eye contact Rinse immediately with plenty of water. Remove any contact lenses and open eyelids wide
apart. Continue to rinse for at least 10 minutes.
Protection of first aiders First aid personnel should wear appropriate protective equipment during any rescue. If it is
suspected that volatile contaminants are still present around the affected person, first aid
personnel should wear an appropriate respirator or self-contained breathing apparatus. Wash
contaminated clothing thoroughly with water before removing it from the affected person, or
wear gloves. It may be dangerous for first aid personnel to carry out mouth-to-mouth
resuscitation.
4.2. Most important symptoms and effects, both acute and delayed
General information See Section 11 for additional information on health hazards. The severity of the symptoms
described will vary dependent on the concentration and the length of exposure.
Inhalation A single exposure may cause the following adverse effects: Headache. Exhaustion and
weakness.
Ingestion May cause sensitisation or allergic reactions in sensitive individuals. Gastrointestinal
symptoms, including upset stomach. Fumes from the stomach contents may be inhaled,
resulting in the same symptoms as inhalation.
Skin contact May cause skin sensitisation or allergic reactions in sensitive individuals. Prolonged contact
may cause dryness of the skin.
Eye contact May cause temporary eye irritation.
4.3. Indication of any immediate medical attention and special treatment needed
Notes for the doctor Treat symptomatically. May cause sensitisation or allergic reactions in sensitive individuals.
SECTION 5: Firefighting measures
5.1. Extinguishing media
Suitable extinguishing media The product is not flammable. Extinguish with alcohol-resistant foam, carbon dioxide, dry
powder or water fog. Use fire-extinguishing media suitable for the surrounding fire.
Unsuitable extinguishing
media
Do not use water jet as an extinguisher, as this will spread the fire.
5.2. Special hazards arising from the substance or mixture
Specific hazards Containers can burst violently or explode when heated, due to excessive pressure build-up.
This product is toxic.
Hazardous combustion
products
Thermal decomposition or combustion products may include the following substances: Toxic
gases or vapours.
5.3. Advice for firefighters
Protective actions during
firefighting
Avoid breathing fire gases or vapours. Evacuate area. Keep upwind to avoid inhalation of
gases, vapours, fumes and smoke. Ventilate closed spaces before entering them. Cool
containers exposed to heat with water spray and remove them from the fire area if it can be
done without risk. Cool containers exposed to flames with water until well after the fire is out.
If a leak or spill has not ignited, use water spray to disperse vapours and protect men stopping
the leak. Control run-off water by containing and keeping it out of sewers and watercourses. If
risk of water pollution occurs, notify appropriate authorities.
Special protective equipment
for firefighters
Wear positive-pressure self-contained breathing apparatus (SCBA) and appropriate protective
clothing. Firefighter's clothing conforming to European standard EN469 (including helmets,
protective boots and gloves) will provide a basic level of protection for chemical incidents.
SECTION 6: Accidental release measures
3/
14