Datasheet
Revision date: 22/08/2018 Revision: 1
Surface Mount Adhesive
5.2. Special hazards arising from the substance or mixture
Specific hazards Containers can burst violently or explode when heated, due to excessive pressure build-up.
Hazardous combustion
products
Thermal decomposition or combustion products may include the following substances:
Harmful gases or vapours.
5.3. Advice for firefighters
Protective actions during
firefighting
Avoid breathing fire gases or vapours. Evacuate area. Cool containers exposed to heat with
water spray and remove them from the fire area if it can be done without risk. Cool containers
exposed to flames with water until well after the fire is out. If a leak or spill has not ignited, use
water spray to disperse vapours and protect men stopping the leak. Avoid discharge to the
aquatic environment. Control run-off water by containing and keeping it out of sewers and
watercourses. If risk of water pollution occurs, notify appropriate authorities.
Special protective equipment
for firefighters
Wear positive-pressure self-contained breathing apparatus (SCBA) and appropriate protective
clothing. Firefighter's clothing conforming to European standard EN469 (including helmets,
protective boots and gloves) will provide a basic level of protection for chemical incidents.
SECTION 6: Accidental release measures
6.1. Personal precautions, protective equipment and emergency procedures
Personal precautions No action shall be taken without appropriate training or involving any personal risk. Keep
unnecessary and unprotected personnel away from the spillage. Wear protective clothing as
described in Section 8 of this safety data sheet. Follow precautions for safe handling
described in this safety data sheet. Wash thoroughly after dealing with a spillage. Ensure
procedures and training for emergency decontamination and disposal are in place. Do not
touch or walk into spilled material. Avoid contact with skin and eyes.
6.2. Environmental precautions
Environmental precautions Avoid discharge into drains or watercourses or onto the ground. Avoid discharge to the
aquatic environment. Large Spillages: Inform the relevant authorities if environmental pollution
occurs (sewers, waterways, soil or air).
6.3. Methods and material for containment and cleaning up
Methods for cleaning up Wear protective clothing as described in Section 8 of this safety data sheet. Clear up spills
immediately and dispose of waste safely. Approach the spillage from upwind. Small Spillages:
If the product is soluble in water, dilute the spillage with water and mop it up. Alternatively, or
if it is not water-soluble, absorb the spillage with an inert, dry material and place it in a suitable
waste disposal container. Large Spillages: If leakage cannot be stopped, evacuate area.
Flush spilled material into an effluent treatment plant, or proceed as follows. Contain and
absorb spillage with sand, earth or other non-combustible material. Place waste in labelled,
sealed containers. Clean contaminated objects and areas thoroughly, observing
environmental regulations. The contaminated absorbent may pose the same hazard as the
spilled material. Flush contaminated area with plenty of water. Wash thoroughly after dealing
with a spillage. Dangerous for the environment. Do not empty into drains. Dispose of waste to
licensed waste disposal site in accordance with the requirements of the local Waste Disposal
Authority.
6.4. Reference to other sections
Reference to other sections For personal protection, see Section 8. See Section 11 for additional information on health
hazards. See Section 12 for additional information on ecological hazards. For waste disposal,
see Section 13.
SECTION 7: Handling and storage
7.1. Precautions for safe handling
4/
13