Datasheet

Cured System:
Cured Density (g/ml)
1.4
Temperature Range (°C)
-60 to +200
Max Temperature (°C) (Short Term (°C)/30 mins)
(Application and Geometry Dependent)
220
Colour (Mixed System)
Black
Hardness (23°C)
A55
Dielectric Strength (kV/mm)
20
Volume Resistivity (ohm-cm)
10
14
Thermal Conductivity (W/m.K)
0.7
Mixing Procedures
Resin Packs
When in Resin pack form, the resin and hardener are mixed by removing the clip and moving the contents around
inside the pack until thoroughly mixed. To remove the clip, remove both end caps, grip each end of the pack and
pull apart gently. By using the removed clip, take special care to push unmixed material from the corners of the
pack. Mixing normally takes from two to four minutes depending on the skill of the operator and the size of the
pack. Both the resin and hardener are evacuated prior to packing so the system is ready for use immediately
after mixing. The corner may be cut from the pack so that it may be used as a simple dispenser.
Bulk Mixing
When mixing, care must be taken to avoid the introduction of excessive amounts of air. Automatic mixing
equipment is available which will not only mix both the resin and hardener accurately in the correct ratio but do
1
2
3
4
5
6