Datasheet

Revision date: 2/6/2019 Revision: 1.1
Silicone Resin SC4003E, Part B
Ingestion Rinse mouth thoroughly with water. Remove any dentures. Give a few small glasses of water
or milk to drink. Stop if the affected person feels sick as vomiting may be dangerous. Do not
induce vomiting unless under the direction of medical personnel. If vomiting occurs, the head
should be kept low so that vomit does not enter the lungs. Never give anything by mouth to an
unconscious person. Move affected person to fresh air and keep warm and at rest in a
position comfortable for breathing. Place unconscious person on their side in the recovery
position and ensure breathing can take place. Maintain an open airway. Loosen tight clothing
such as collar, tie or belt.
Skin Contact Rinse with water.
Eye contact Rinse immediately with plenty of water. Remove any contact lenses and open eyelids wide
apart. Continue to rinse for at least 10 minutes.
Protection of first aiders First aid personnel should wear appropriate protective equipment during any rescue.
Most important symptoms and effects, both acute and delayed
General information See Section 11 for additional information on health hazards. The severity of the symptoms
described will vary dependent on the concentration and the length of exposure.
Inhalation Prolonged inhalation of high concentrations may damage respiratory system.
Ingestion Gastrointestinal symptoms, including upset stomach. Fumes from the stomach contents may
be inhaled, resulting in the same symptoms as inhalation.
Skin contact Prolonged contact may cause dryness of the skin.
Eye contact Irritating to eyes.
Indication of immediate medical attention and special treatment needed
Notes for the doctor Treat symptomatically.
5. Fire-fighting measures
Extinguishing media
Suitable extinguishing media The product is not flammable. Extinguish with alcohol-resistant foam, carbon dioxide, dry
powder or water fog. Use fire-extinguishing media suitable for the surrounding fire.
Unsuitable extinguishing
media
Do not use water jet as an extinguisher, as this will spread the fire.
Special hazards arising from the substance or mixture
Specific hazards Containers can burst violently or explode when heated, due to excessive pressure build-up.
Hazardous combustion
products
Thermal decomposition or combustion products may include the following substances:
Harmful gases or vapors.
Advice for firefighters
Protective actions during
firefighting
Avoid breathing fire gases or vapors. Evacuate area. Cool containers exposed to heat with
water spray and remove them from the fire area if it can be done without risk. Cool containers
exposed to flames with water until well after the fire is out. If a leak or spill has not ignited, use
water spray to disperse vapors and protect men stopping the leak. Control run-off water by
containing and keeping it out of sewers and watercourses. If risk of water pollution occurs,
notify appropriate authorities.
Special protective equipment
for firefighters
Wear positive-pressure self-contained breathing apparatus (SCBA) and appropriate protective
clothing. Standard Firefighter's clothing including helmets, protective boots and gloves will
provide a basic level of protection for chemical incidents.
6. Accidental release measures
3/
12