Datasheet

Revision date: 06/02/2019 Revision: 1.1

Silicone Resin SC4003E, Part B

6.3. Methods and material for containment and cleaning up

Methods for cleaning up Wear protective clothing as described in Section 8 of this safety data sheet. Clear up spills

immediately and dispose of waste safely. Approach the spillage from upwind. Small Spillages:

If the product is soluble in water, dilute the spillage with water and mop it up. Alternatively, or

if it is not water-soluble, absorb the spillage with an inert, dry material and place it in a suitable

waste disposal container. Large Spillages: If leakage cannot be stopped, evacuate area.

Flush spilled material into an effluent treatment plant, or proceed as follows. Contain and

absorb spillage with sand, earth or other non-combustible material. Place waste in labelled,

sealed containers. Clean contaminated objects and areas thoroughly, observing

environmental regulations. The contaminated absorbent may pose the same hazard as the

spilled material. Flush contaminated area with plenty of water. Wash thoroughly after dealing

with a spillage. Dispose of waste to licensed waste disposal site in accordance with the

requirements of the local Waste Disposal Authority.

6.4. Reference to other sections

Reference to other sections For personal protection, see Section 8. See Section 11 for additional information on health

hazards. See Section 12 for additional information on ecological hazards. For waste disposal,

see Section 13.

SECTION 7: Handling and storage

7.1. Precautions for safe handling

Usage precautions Read and follow manufacturer's recommendations. Wear protective clothing as described in

Section 8 of this safety data sheet. Keep away from food, drink and animal feeding stuffs.

Handle all packages and containers carefully to minimise spills. Keep container tightly sealed

when not in use. Avoid the formation of mists. Do not handle until all safety precautions have

been read and understood. Do not handle broken packages without protective equipment.

Advice on general

occupational hygiene

Wash promptly if skin becomes contaminated. Take off contaminated clothing. Wash

contaminated clothing before reuse. Do not eat, drink or smoke when using this product.

Wash at the end of each work shift and before eating, smoking and using the toilet. Change

work clothing daily before leaving workplace.

7.2. Conditions for safe storage, including any incompatibilities

Storage precautions Store away from incompatible materials (see Section 10). Store in accordance with local

regulations. Keep only in the original container. Keep container tightly closed, in a cool, well

ventilated place. Keep containers upright. Protect containers from damage. Bund storage

facilities to prevent soil and water pollution in the event of spillage. The storage area floor

should be leak-tight, jointless and not absorbent.

Storage class Chemical storage.

7.3. Specific end use(s)

Specific end use(s) The identified uses for this product are detailed in Section 1.2.

SECTION 8: Exposure controls/Personal protection

8.1. Control parameters

8.2. Exposure controls

Protective equipment