Datasheet

Revision date: 6/02/2019 Revision: 1.1
Silicone Resin SC4003E, Part B
Respiratory protection Respiratory protection complying with an approved standard should be worn if a risk
assessment indicates inhalation of contaminants is possible. Ensure all respiratory protective
equipment is suitable for its intended use and complies with Australia/New Zealand Standard
AS/NZS 1716. Check that the respirator fits tightly and the filter is changed regularly. Gas and
combination filter cartridges should comply with Australia/New Zealand Standard AS/NZS
1716. Full face mask respirators with replaceable filter cartridges should comply with
Australia/New Zealand Standard AS/NZS 1716. Half mask and quarter mask respirators with
replaceable filter cartridges should comply with Australia/New Zealand Standard AS/NZS
1716.
Environmental exposure
controls
Keep container tightly sealed when not in use.
SECTION 9: Physical and chemical properties
Information on basic physical and chemical properties
Appearance Liquid.
Colour White.
Odour Not known.
Odour threshold Not available.
pH Not available.
Melting point Not available.
Initial boiling point and range Not available.
Flash point > 100°C
Evaporation rate Not available.
Evaporation factor Not available.
Flammability (solid, gas) Not available.
Flammability Limit - Lower(%) Not available.
Other flammability Not available.
Vapour pressure Not available.
Vapour density Not available.
Relative density Not available.
Bulk density 1.4 kg/l
Solubility(ies) Not available.
Partition coefficient Not available.
Auto-ignition temperature Not available.
Decomposition Temperature Not available.
Viscosity 3000-3500 mPa s @ 23°C
Explosive properties Not considered to be explosive.
Oxidising properties Does not meet the criteria for classification as oxidising.
SECTION 10: Stability and reactivity
6/
10