Datasheet

Revision date: 22/06/2017 Revision: 0

High Gloss Paint

Storage precautions Store away from incompatible materials (see Section 10). Store in accordance with local

regulations. Keep away from oxidising materials, heat and flames. Keep only in the original

container. Keep container tightly closed, in a cool, well ventilated place. Keep containers

upright. Protect containers from damage. Protect from sunlight. Do not store near heat

sources or expose to high temperatures. Do not expose to temperatures exceeding

50°C/122°F. Bund storage facilities to prevent soil and water pollution in the event of spillage.

The storage area floor should be leak-tight, jointless and not absorbent.

Storage class Miscellaneous hazardous material storage.

7.3. Specific end use(s)

Specific end use(s) The identified uses for this product are detailed in Section 1.2.

SECTION 8: Exposure Controls/personal protection

8.1. Control parameters

Occupational exposure limits

Acetone

Long-term exposure limit (8-hour TWA): WEL 500 ppm 1210 mg/m³

Short-term exposure limit (15-minute): WEL 1500 ppm 3620 mg/m³

Petroleum gases, liquefied

Long-term exposure limit (8-hour TWA): WEL 1000 ppm 1750 mg/m³

Short-term exposure limit (15-minute): WEL 1250 ppm 2180 mg/m³

xylene

Long-term exposure limit (8-hour TWA): WEL 50 ppm 220 mg/m³

Short-term exposure limit (15-minute): WEL 100 ppm 441 mg/m³

Ethylbenzene

Long-term exposure limit (8-hour TWA): WEL 100 ppm 441 mg/m³

Short-term exposure limit (15-minute): WEL 125 ppm 552 mg/m³

WEL = Workplace Exposure Limit

Sk = Can be absorbed through the skin.

8.2. Exposure controls

Protective equipment

Appropriate engineering

controls

Provide adequate ventilation. Personal, workplace environment or biological monitoring may

be required to determine the effectiveness of the ventilation or other control measures and/or

the necessity to use respiratory protective equipment. Use process enclosures, local exhaust

ventilation or other engineering controls as the primary means to minimise worker exposure.

Personal protective equipment should only be used if worker exposure cannot be controlled

adequately by the engineering control measures. Ensure control measures are regularly

inspected and maintained. Ensure operatives are trained to minimise exposure.

Eye/face protection Eyewear complying with an approved standard should be worn if a risk assessment indicates

eye contact is possible. Personal protective equipment for eye and face protection should

comply with European Standard EN166. Wear tight-fitting, chemical splash goggles or face

shield. If inhalation hazards exist, a full-face respirator may be required instead.