Datasheet

Page 1

HTS

Silicone Heat Transfer Compound

HTS is a non-curing heat transfer paste, designed for use as a thermal interface material. It is recommended

where the efficient and reliable thermal coupling of electronic components or heat dissipation between any

surfaces are required. HTS is based on a silicone oil, offering an exceptionally wide operating temperature

range.

 General purpose thermal management paste; excellent stability in a range of conditions

 Based on a silicone oil; offers an exceptionally wide operating temperature range

 Good thermal conductivity; designed for use as a thermal interface material

 Non-curing paste; allows simple and efficient rework of components if required

Approvals RoHS-2 Compliant (2011/65/EU): Yes

NATO Stock No. – EHTS20S: 5999-99-225-2132

Typical Properties Colour: White

Base: Silicone Oil

Thermo-conductive Component: Powdered metal oxides

Density @ 20°C (g/ml): 2.1

Cone Penetration @ 20°C: 300

Viscosity @ 1rpm (Pa s) : 201-227

Thermal Conductivity (Guarded Hot Plate): 0.9 W/m.K

Thermal Conductivity (Heat Flow): 0.7 W/m.K (calculated)

Temperature Range: -50°C to +200°C

Weight Loss after 96 hours @ 100°C: 0.8%

Permittivity @ 10

Hz: 4.9

Volume Resistivity: 1 x 10

Ohms-cm

Dielectric Strength: 18 kV/mm

Description Packing Order Code Shelf Life

Silicone Heat Transfer Compound 2 ml Syringe HTS02S 48 months

10ml Syringe HTS10S 48 months

30ml Syringe HTS30SL 48 months

35 ml Luer Lock Syringe HTS35SL 48 months

100 g Tube HTS100T 48 months

1 Kg Bulk HTS01K 72 months

25 Kg Bulk HTS25K 72 months

PAGE 1
Page 1 HTS Silicone Heat Transfer Compound HTS is a non-curing heat transfer paste, designed for use as a thermal interface material. It is recommended where the efficient and reliable thermal coupling of electronic components or heat dissipation between any surfaces are required. HTS is based on a silicone oil, offering an exceptionally wide operating temperature range.
PAGE 2
Page 2 Directions for Use Thermal pastes can be applied to the base and mounting studs of diodes, transistors, thyristors, heat sinks, silicone rectifiers and semi-conductors, thermostats, power resistors and radiators, to name but a few. When the contact surfaces are placed together, a firm metal-to-metal contact will only be achieved on 40 – 60% of the interface, depending on the smoothness of the surfaces.