Datasheet

Revision date: 22/08/2018 Revision: 1
Non-Silicone Heat Transfer Compound Plus
Methods for cleaning up Wear protective clothing as described in Section 8 of this safety data sheet. Clear up spills
immediately and dispose of waste safely. Approach the spillage from upwind. Small Spillages:
If the product is soluble in water, dilute the spillage with water and mop it up. Alternatively, or
if it is not water-soluble, absorb the spillage with an inert, dry material and place it in a suitable
waste disposal container. Large Spillages: If leakage cannot be stopped, evacuate area.
Flush spilled material into an effluent treatment plant, or proceed as follows. Contain and
absorb spillage with sand, earth or other non-combustible material. Place waste in labelled,
sealed containers. Clean contaminated objects and areas thoroughly, observing
environmental regulations. The contaminated absorbent may pose the same hazard as the
spilled material. Flush contaminated area with plenty of water. Wash thoroughly after dealing
with a spillage. Dangerous for the environment. Do not empty into drains. Dispose of waste to
licensed waste disposal site in accordance with the requirements of the local Waste Disposal
Authority.
6.4. Reference to other sections
Reference to other sections For personal protection, see Section 8. See Section 11 for additional information on health
hazards. See Section 12 for additional information on ecological hazards. For waste disposal,
see Section 13.
SECTION 7: Handling and storage
7.1. Precautions for safe handling
Usage precautions Read and follow manufacturer's recommendations. Wear protective clothing as described in
Section 8 of this safety data sheet. Keep away from food, drink and animal feeding stuffs.
Handle all packages and containers carefully to minimise spills. Keep container tightly sealed
when not in use. Avoid the formation of mists. Avoid discharge to the aquatic environment. Do
not handle until all safety precautions have been read and understood. Do not handle broken
packages without protective equipment. Do not reuse empty containers.
Advice on general
occupational hygiene
Wash promptly if skin becomes contaminated. Take off contaminated clothing. Wash
contaminated clothing before reuse. Do not eat, drink or smoke when using this product.
Wash at the end of each work shift and before eating, smoking and using the toilet. Change
work clothing daily before leaving workplace.
7.2. Conditions for safe storage, including any incompatibilities
Storage precautions Store away from incompatible materials (see Section 10). Store in accordance with local
regulations. Keep only in the original container. Keep container tightly closed, in a cool, well
ventilated place. Keep containers upright. Protect containers from damage. Bund storage
facilities to prevent soil and water pollution in the event of spillage. The storage area floor
should be leak-tight, jointless and not absorbent.
Storage class Miscellaneous hazardous material storage.
7.3. Specific end use(s)
Specific end use(s) The identified uses for this product are detailed in Section 1.2.
SECTION 8: Exposure controls/Personal protection
8.1. Control parameters
Occupational exposure limits
Aluminium Oxide
Long-term exposure limit (8-hour TWA): WEL 4 mg/m³ respirable dust
Long-term exposure limit (8-hour TWA): WEL 10 mg/m³ inhalable dust
WEL = Workplace Exposure Limit
8.2. Exposure controls
4/
11