Datasheet

Revision date: 14/03/2017 Revision: 0
Cutting Fluid
Environmental precautions Large Spillages: Inform the relevant authorities if environmental pollution occurs (sewers,
waterways, soil or air).
6.3. Methods and material for containment and cleaning up
Methods for cleaning up Wear protective clothing as described in Section 8 of this safety data sheet. Clear up spills
immediately and dispose of waste safely. Eliminate all ignition sources if safe to do so. No
smoking, sparks, flames or other sources of ignition near spillage. Approach the spillage from
upwind. Under normal conditions of handling and storage, spillages from aerosol containers
are unlikely. If aerosol cans are ruptured, care should be taken due to the rapid escape of the
pressurised contents and propellant. Small Spillages: Wipe up with an absorbent cloth and
dispose of waste safely. Large Spillages: If the product is soluble in water, dilute the spillage
with water and mop it up. Alternatively, or if it is not water-soluble, absorb the spillage with an
inert, dry material and place it in a suitable waste disposal container. Flush contaminated area
with plenty of water. Wash thoroughly after dealing with a spillage. Dispose of waste to
licensed waste disposal site in accordance with the requirements of the local Waste Disposal
Authority.
6.4. Reference to other sections
Reference to other sections For personal protection, see Section 8. See Section 11 for additional information on health
hazards. See Section 12 for additional information on ecological hazards. For waste disposal,
see Section 13.
SECTION 7: Handling and storage
7.1. Precautions for safe handling
Usage precautions Read and follow manufacturer's recommendations. Wear protective clothing as described in
Section 8 of this safety data sheet. Keep away from food, drink and animal feeding stuffs.
Avoid exposing aerosol containers to high temperatures or direct sunlight. The product is
flammable. Keep away from heat, hot surfaces, sparks, open flames and other ignition
sources. No smoking. Do not handle until all safety precautions have been read and
understood. Do not handle broken packages without protective equipment. Do not spray on
an open flame or other ignition source. Do not pierce or burn, even after use. Spray will
evaporate and cool rapidly and may cause frostbite or cold burns if in contact with skin. Avoid
contact with eyes. Avoid inhalation of vapours and spray/mists.
Advice on general
occupational hygiene
Wash promptly if skin becomes contaminated. Take off contaminated clothing. Wash
contaminated clothing before reuse. Do not eat, drink or smoke when using this product.
Wash at the end of each work shift and before eating, smoking and using the toilet. Change
work clothing daily before leaving workplace.
7.2. Conditions for safe storage, including any incompatibilities
Storage precautions Store away from incompatible materials (see Section 10). Store in accordance with local
regulations. Keep away from oxidising materials, heat and flames. Keep only in the original
container. Keep container tightly closed, in a cool, well ventilated place. Keep containers
upright. Protect containers from damage. Protect from sunlight. Do not store near heat
sources or expose to high temperatures. Do not expose to temperatures exceeding
50°C/122°F. Bund storage facilities to prevent soil and water pollution in the event of spillage.
The storage area floor should be leak-tight, jointless and not absorbent.
Storage class Chemical storage.
7.3. Specific end use(s)
Specific end use(s) The identified uses for this product are detailed in Section 1.2.
SECTION 8: Exposure Controls/personal protection
8.1. Control parameters
4/
13