Safety data sheet

Revision: 7
Revision date: 18/03/2015
SCC3 CONFORMAL COATING
DIMETHYL ETHER
Long-term exposure limit (8-hour TWA): WEL 400 ppm 766 mg/m3
Short-term exposure limit (15-minute): WEL 500 ppm 958 mg/m3
XYLENE
Long-term exposure limit (8-hour TWA): WEL 50 ppm 220 mg/m3
Short-term exposure limit (15-minute): WEL 100 ppm 441 mg/m3
Sk
CYCLOHEXANE
Long-term exposure limit (8-hour TWA): WEL 100 ppm 350 mg/m3
Short-term exposure limit (15-minute): WEL 300 ppm 1050 mg/m3
1-METHOXY-2-PROPANOL
Long-term exposure limit (8-hour TWA): WEL 100 ppm 375 mg/m3
Short-term exposure limit (15-minute): WEL 150 ppm 560 mg/m3
Sk
ETHYLBENZENE
Long-term exposure limit (8-hour TWA): WEL 100 ppm(Sk) 441 mg/m3(Sk)
Short-term exposure limit (15-minute): WEL 125 ppm(Sk) 552 mg/m3(Sk)
HEPTANE
Long-term exposure limit (8-hour TWA): WEL 500 ppm
Short-term exposure limit (15-minute): WEL
HEXANE-norm
Long-term exposure limit (8-hour TWA): WEL 20 ppm 72 mg/m3
Short-term exposure limit (15-minute): WEL
WEL = Workplace Exposure Limit
Sk = Can be absorbed through the skin.
Sk = Can be absorbed through skin.
8.2. Exposure controls
Protective equipment
Appropriate engineering controls
All handling should only take place in well-ventilated areas. Provide adequate general and local exhaust ventilation. Observe
any occupational exposure limits for the product or ingredients.
Eye/face protection
Eyewear complying with an approved standard should be worn if a risk assessment indicates eye contact is possible. EN166
Hand protection
Chemical-resistant, impervious gloves complying with an approved standard should be worn if a risk assessment indicates skin
contact is possible. The most suitable glove should be chosen in consultation with the glove supplier/manufacturer, who can
provide information about the breakthrough time of the glove material. It is recommended that gloves are made of the following
material: Nitrile rubber. Polyvinyl alcohol (PVA). Viton rubber (fluoro rubber). To protect hands from chemicals, gloves should
comply with European Standard EN374.
Other skin and body protection
Wear appropriate clothing to prevent any possibility of liquid contact and repeated or prolonged vapour contact.
Hygiene measures
Use engineering controls to reduce air contamination to permissible exposure level. Provide eyewash station. Do not smoke in
work area. Wash hands at the end of each work shift and before eating, smoking and using the toilet. When using do not eat,
drink or smoke.
Respiratory protection
6/15