Datasheet

Revision date: 24/04/2019 Revision: 2
Airduster Plus Invertible 200ml
Usage precautions Read and follow manufacturer's recommendations. Wear protective clothing as described in
Section 8 of this safety data sheet. Keep away from food, drink and animal feeding stuffs.
Avoid exposing aerosol containers to high temperatures or direct sunlight. Do not handle until
all safety precautions have been read and understood. Do not handle broken packages
without protective equipment. Do not spray on an open flame or other ignition source. Do not
pierce or burn, even after use. Spray will evaporate and cool rapidly and may cause frostbite
or cold burns if in contact with skin. Avoid contact with eyes. Avoid inhalation of vapours and
spray/mists.
Advice on general
occupational hygiene
Wash promptly if skin becomes contaminated. Take off contaminated clothing. Wash
contaminated clothing before reuse. Do not eat, drink or smoke when using this product.
Wash at the end of each work shift and before eating, smoking and using the toilet. Change
work clothing daily before leaving workplace.
7.2. Conditions for safe storage, including any incompatibilities
Storage precautions Store away from incompatible materials (see Section 10). Keep only in the original container.
Keep container tightly closed, in a cool, well ventilated place. Keep containers upright. Protect
containers from damage. Protect from sunlight. Do not store near heat sources or expose to
high temperatures. Do not expose to temperatures exceeding 50°C/122°F. Bund storage
facilities to prevent soil and water pollution in the event of spillage. The storage area floor
should be leak-tight, jointless and not absorbent.
Storage class Chemical storage.
7.3. Specific end use(s)
Specific end use(s) The identified uses for this product are detailed in Section 1.2.
SECTION 8: Exposure controls/Personal protection
8.1. Control parameters
8.2. Exposure controls
Protective equipment
Appropriate engineering
controls
Provide adequate ventilation. Personal, workplace environment or biological monitoring may
be required to determine the effectiveness of the ventilation or other control measures and/or
the necessity to use respiratory protective equipment. Use process enclosures, local exhaust
ventilation or other engineering controls as the primary means to minimise worker exposure.
Personal protective equipment should only be used if worker exposure cannot be controlled
adequately by the engineering control measures. Ensure control measures are regularly
inspected and maintained. Ensure operatives are trained to minimise exposure.
Eye/face protection Eyewear complying with an approved standard should be worn if a risk assessment indicates
eye contact is possible. Personal protective equipment for eye and face protection should
comply with European Standard EN166. Unless the assessment indicates a higher degree of
protection is required, the following protection should be worn: Tight-fitting safety glasses.
Hand protection Chemical-resistant, impervious gloves complying with an approved standard should be worn if
a risk assessment indicates skin contact is possible. The most suitable glove should be
chosen in consultation with the glove supplier/manufacturer, who can provide information
about the breakthrough time of the glove material. To protect hands from chemicals, gloves
should comply with European Standard EN374. Considering the data specified by the glove
manufacturer, check during use that the gloves are retaining their protective properties and
change them as soon as any deterioration is detected. Frequent changes are recommended.
4/
10