Datasheet

Page 3
Spraying - Aerosol
When applying DCA in aerosol form care must be taken to ensure the can is not shaken before use. Shaking
the can will introduce excessive air bubbles and will give a poor coating finish.
The can should be held at 45°, and 200mm from the substrate to be coated. The valve should then be
depressed when the can is pointing slightly off target and moved at about 100mm/s across the target. To ensure
the best coating results are achieved try to use a smooth sweeping motion with small overlap for successive
rows.
0
50
100
150
200
250
16 17 18 19 20 21 22 23 24 25 26 27 28 29 30
Viscosity (mPa s)
Temperature (⁰C)
Viscosity Change with Temperature - DCA
0
50
100
150
200
250
1:0 20:1 10:1 5:1 2:1 1:1 1:1.5 1:2 1:2.5 1:3
Viscosity (mPa s)
Mix Ratio - DCA:DCT
Viscosity Chart - DCA:DCT