Datasheet

Revision date: 05/06/2017 Revision: 0

Clear Protective Lacquer

Storage precautions Store away from incompatible materials (see Section 10). Store in accordance with local

regulations. Keep away from oxidising materials, heat and flames. Keep only in the original

container. Keep container tightly closed, in a cool, well ventilated place. Keep containers

upright. Protect containers from damage. Protect from sunlight. Do not store near heat

sources or expose to high temperatures. Do not expose to temperatures exceeding

50°C/122°F. Bund storage facilities to prevent soil and water pollution in the event of spillage.

The storage area floor should be leak-tight, jointless and not absorbent.

Storage class Chemical storage.

7.3. Specific end use(s)

Specific end use(s) The identified uses for this product are detailed in Section 1.2.

SECTION 8: Exposure Controls/personal protection

8.1. Control parameters

Occupational exposure limits

Dimethylether

Long-term exposure limit (8-hour TWA): WEL 400 ppm 766 mg/m³

Short-term exposure limit (15-minute): WEL 500 ppm 958 mg/m³

Propan-2-ol

Long-term exposure limit (8-hour TWA): WEL 400 ppm 999 mg/m³

Short-term exposure limit (15-minute): WEL 500 ppm 1250 mg/m³

n-Butyl acetate

Long-term exposure limit (8-hour TWA): WEL 150 ppm 724 mg/m³

Short-term exposure limit (15-minute): WEL 200 ppm 966 mg/m³

4-Methylpentan-2-one

Long-term exposure limit (8-hour TWA): WEL 50 ppm 208 mg/m³

Short-term exposure limit (15-minute): WEL 100 ppm 416 mg/m³

WEL = Workplace Exposure Limit

Sk = Can be absorbed through the skin.

8.2. Exposure controls

Protective equipment

Appropriate engineering

controls

Provide adequate ventilation. Personal, workplace environment or biological monitoring may

be required to determine the effectiveness of the ventilation or other control measures and/or

the necessity to use respiratory protective equipment. Use process enclosures, local exhaust

ventilation or other engineering controls as the primary means to minimise worker exposure.

Personal protective equipment should only be used if worker exposure cannot be controlled

adequately by the engineering control measures. Ensure control measures are regularly

inspected and maintained. Ensure operatives are trained to minimise exposure.

Eye/face protection Eyewear complying with an approved standard should be worn if a risk assessment indicates

eye contact is possible. Personal protective equipment for eye and face protection should

comply with European Standard EN166. Wear tight-fitting, chemical splash goggles or face

shield. If inhalation hazards exist, a full-face respirator may be required instead.