Datasheet

Revision date: 22/08/2018 Revision: 1
Contact Cleaning Strips
8.1. Control parameters
8.2. Exposure controls
Protective equipment
Appropriate engineering
controls
Provide adequate ventilation. Good general ventilation should be adequate to control worker
exposure to airborne contaminants.
Eye/face protection Eyewear complying with an approved standard should be worn if a risk assessment indicates
eye contact is possible. Personal protective equipment for eye and face protection should
comply with European Standard EN166. The following protection should be worn: Chemical
splash goggles.
Hand protection Chemical-resistant, impervious gloves complying with an approved standard should be worn if
a risk assessment indicates skin contact is possible. The most suitable glove should be
chosen in consultation with the glove supplier/manufacturer, who can provide information
about the breakthrough time of the glove material. To protect hands from chemicals, gloves
should comply with European Standard EN374. Considering the data specified by the glove
manufacturer, check during use that the gloves are retaining their protective properties and
change them as soon as any deterioration is detected. Frequent changes are recommended.
Other skin and body
protection
Appropriate footwear and additional protective clothing complying with an approved standard
should be worn if a risk assessment indicates skin contamination is possible.
Hygiene measures Provide eyewash station and safety shower. Contaminated work clothing should not be
allowed out of the workplace. Wash contaminated clothing before reuse. Clean equipment
and the work area every day. Good personal hygiene procedures should be implemented.
Wash at the end of each work shift and before eating, smoking and using the toilet. When
using do not eat, drink or smoke.
Respiratory protection Respiratory protection complying with an approved standard should be worn if a risk
assessment indicates inhalation of contaminants is possible. Provide adequate ventilation.
Large Spillages: If ventilation is inadequate, suitable respiratory protection must be worn.
Environmental exposure
controls
Not regarded as dangerous for the environment.
SECTION 9: Physical and chemical properties
9.1. Information on basic physical and chemical properties
Appearance Liquid.
Colour Light brown.
Odour Not known.
Odour threshold Not available.
pH Not available.
Melting point Not available.
Initial boiling point and range Not available.
Flash point 242°C Cleveland open cup.
Evaporation rate Not available.
Evaporation factor Not available.
4/
9