Datasheet

Page 1
CCRG
Conformal Coating Remover Gel
CCRG is a thixotropic gel formulated to remove solvent resistant conformal coatings, including Electrolube DCA,
DCB, DCR, DCRT, DCE, PUC, URC and WBP/S. This product does not contain methylene chloride.
Approvals RoHS-2 Compliant (2011/65/EU): Yes
Liquid Properties Appearance: Colourless Gel
Density @ 20°C (g/ml): 0.950 g/ml
VOC Content: 98%
Flash Point: -17°C CC (Closed cup)
Description Packaging Order Code Shelf Life
Conformal Coating Remover Gel 1 Litre CCRG01L 36 Months
Directions for Use
Areas where the conformal coating is to be removed should be identified. CCRG should be applied in small
sections using a brush or syringe. CCRG will then start to attack the coating lifting it from the surface, after
which the gel should be wiped off or promptly rinsed off with deionised water – do not allow the gel to fully dry
out.
This method should be repeated until the required area is clean.
CCRG will not generally damage metals; however, there may be some corrosion on ferrous metals if materials
are soaked for prolonged periods. CCRG will attack several plastics and also remove component identification
markings if prolonged exposure is permitted. Where possible, a compatibility test with sensitive plastics should
be conducted prior to full-scale use.
A removal solvent (RRS) is also supplied, should a liquid product be required. CCRG is highly flammable so
care must be taken when using this material. Refer to the Material Safety Data Sheet for additional information.
Revision 2: Oct 2017