Datasheet

Revision date: 04/12/2016 Revision: 0
Bloc'Lube Tamper Evident Seal Green
Methods for cleaning up Wear protective clothing as described in Section 8 of this safety data sheet. Clear up spills
immediately and dispose of waste safely. Eliminate all ignition sources if safe to do so. No
smoking, sparks, flames or other sources of ignition near spillage. Do not allow material to
enter confined spaces, due to the risk of explosion. Approach the spillage from upwind. Small
Spillages: If the product is soluble in water, dilute the spillage with water and mop it up.
Alternatively, or if it is not water-soluble, absorb the spillage with an inert, dry material and
place it in a suitable waste disposal container. Large Spillages: If leakage cannot be stopped,
evacuate area. Flush spilled material into an effluent treatment plant, or proceed as follows.
Contain and absorb spillage with sand, earth or other non-combustible material. Place waste
in labelled, sealed containers. Clean contaminated objects and areas thoroughly, observing
environmental regulations. The contaminated absorbent may pose the same hazard as the
spilled material. Flush contaminated area with plenty of water. Wash thoroughly after dealing
with a spillage. Dispose of waste to licensed waste disposal site in accordance with the
requirements of the local Waste Disposal Authority.
6.4. Reference to other sections
Reference to other sections For personal protection, see Section 8. See Section 11 for additional information on health
hazards. See Section 12 for additional information on ecological hazards. For waste disposal,
see Section 13.
SECTION 7: Handling and storage
7.1. Precautions for safe handling
Usage precautions Read and follow manufacturer's recommendations. Wear protective clothing as described in
Section 8 of this safety data sheet. Keep away from food, drink and animal feeding stuffs.
Handle all packages and containers carefully to minimise spills. Keep container tightly sealed
when not in use. Avoid the formation of mists. The product is flammable. Keep away from
heat, hot surfaces, sparks, open flames and other ignition sources. No smoking. In use may
form flammable/explosive vapour-air mixture. Vapours may accumulate on the floor and in
low-lying areas. Use explosion-proof electrical, ventilating and lighting equipment. Use only
non-sparking tools. Take precautionary measures against static discharges. Do not handle
until all safety precautions have been read and understood. Do not handle broken packages
without protective equipment. Do not reuse empty containers.
Advice on general
occupational hygiene
Wash promptly if skin becomes contaminated. Take off contaminated clothing. Wash
contaminated clothing before reuse. Do not eat, drink or smoke when using this product.
Wash at the end of each work shift and before eating, smoking and using the toilet. Change
work clothing daily before leaving workplace.
7.2. Conditions for safe storage, including any incompatibilities
Storage precautions Store away from incompatible materials (see Section 10). Store in accordance with local
regulations. Eliminate all sources of ignition. Take precautionary measures against static
discharges. Earth container and transfer equipment to eliminate sparks from static electricity.
Keep away from oxidising materials, heat and flames. Keep only in the original container.
Keep container tightly closed, in a cool, well ventilated place. Keep containers upright. Protect
containers from damage. Bund storage facilities to prevent soil and water pollution in the
event of spillage. The storage area floor should be leak-tight, jointless and not absorbent.
Storage class Flammable liquid storage.
7.3. Specific end use(s)
Specific end use(s) The identified uses for this product are detailed in Section 1.2.
SECTION 8: Exposure Controls/personal protection
8.1. Control parameters
Occupational exposure limits
5/
16