Datasheet

Revision date: 22/08/2018 Revision: 1

Aromatic Free Acrylic Coating

Usage precautions Read and follow manufacturer's recommendations. Wear protective clothing as described in

Section 8 of this safety data sheet. Keep away from food, drink and animal feeding stuffs.

Avoid exposing aerosol containers to high temperatures or direct sunlight. The product is

flammable. Keep away from heat, hot surfaces, sparks, open flames and other ignition

sources. No smoking. Do not handle until all safety precautions have been read and

understood. Do not handle broken packages without protective equipment. Do not spray on

an open flame or other ignition source. Do not pierce or burn, even after use. Spray will

evaporate and cool rapidly and may cause frostbite or cold burns if in contact with skin. Avoid

contact with eyes. Avoid inhalation of vapours and spray/mists.

Advice on general

occupational hygiene

Wash promptly if skin becomes contaminated. Take off contaminated clothing. Wash

contaminated clothing before reuse. Do not eat, drink or smoke when using this product.

Wash at the end of each work shift and before eating, smoking and using the toilet. Change

work clothing daily before leaving workplace.

7.2. Conditions for safe storage, including any incompatibilities

Storage precautions Store away from incompatible materials (see Section 10). Store in accordance with local

regulations. Keep away from oxidising materials, heat and flames. Keep only in the original

container. Keep container tightly closed, in a cool, well ventilated place. Keep containers

upright. Protect containers from damage. Protect from sunlight. Do not store near heat

sources or expose to high temperatures. Do not expose to temperatures exceeding

50°C/122°F. Bund storage facilities to prevent soil and water pollution in the event of spillage.

The storage area floor should be leak-tight, jointless and not absorbent.

Storage class Chemical storage.

7.3. Specific end use(s)

Specific end use(s) The identified uses for this product are detailed in Section 1.2.

SECTION 8: Exposure controls/Personal protection

8.1. Control parameters

Occupational exposure limits

Dimethylether

Long-term exposure limit (8-hour TWA): WEL 400 ppm 766 mg/m³

Short-term exposure limit (15-minute): WEL 500 ppm 958 mg/m³

n-Butyl acetate

Long-term exposure limit (8-hour TWA): WEL 150 ppm 724 mg/m³

Short-term exposure limit (15-minute): WEL 200 ppm 966 mg/m³

butanone

Long-term exposure limit (8-hour TWA): WEL 200 ppm 600 mg/m³

Short-term exposure limit (15-minute): WEL 300 ppm 899 mg/m³

WEL = Workplace Exposure Limit

Sk = Can be absorbed through the skin.

8.2. Exposure controls

Protective equipment