Service manual

Wells-Garnder Color Vector Monitor Guide
Page 67 of 73
DEFLECTION BOARD
The Deflection board is the main PCB mounted right behind and below the monitor tube.
Zanen WG6100 Deflection PCB Parts
Location Part Number Upgrade? Notes
R100 15 ohm ½ watt resistor Brn/Grn/Blk
R101 15 ohm ½ watt resistor Brn/Grn/Blk
R102 330 ohm ¼ watt resistor Org/Org/Brn
R103 330 ohm ¼ watt resistor Org/Org/Brn
D104 1N4148 diode
D105 1N4148 diode
ZD100 1N4750 diode 27v
Some boards mislabel this diode
as "R104".
ZD101 1N4750 diode 27v
Some boards mislabel this diode
as "R105".
Q100 MPSA06 (NTE287)
Q101 MPSA56 (NTE159) Yes
Upgrade to NTE50 if not using
LV2000
Note: All the above parts are located in the low voltage section of the Deflection board.
Important: if you are installing an LV2000 (highly recommended), you do not need to install
ANY of the above parts. They will all be removed and replaced by the LV2000 installation.