Owner`s manual

Electro-Voice ZxA1 Series Owner’s Manual

Tripod and Floor Monitor Operation (cont.)

Figure 2b:

ZxA1 on Tripod Stand

Figure 2c:

ZxA1and ZxA1-Sub Full-Range/Sub Stack with Pole Mount

Tripod

Electro-Voice ZxA1 speakers include 35 mm (1-3/8 inch) stand mounts to allow mounting on tripod stands. Make sure to:

• Check the specifications of the speaker stand to be certain it is capable of supporting the weight of the speaker.

• Check the speaker stand is placed on a flat, stable surface and fully extend the legs of the

stand. Do not try to make the stand “taller” and compromise its structural integrity.

• Route cables and position the stand so performers, production crew and audience

members will not trip over the stand or cables and pull the speaker system over.

• Secure cables with wire ties or tape whenever possible.

• Do not attempt to suspend more than one speaker on a stand designed for a single speaker.

• Unless you are confident you can safely handle lifting the weight of the speaker

onto the stand, ask another person to help you place it.

• Tighten the set screw to minimize rattling and to prevent the speaker from rotating during use.

Pole Mount

Electro-Voice ZxA1-Sub speakers include 35 mm (1-3/8 inch) pole mount cups to allow mounting a full range speaker above it.

Make sure to:

• Use a speaker pole that is no longer than 1.2 m (4 ft) and mount a speaker weighing no more than 11.3 kg (25 lb).

• Check that the ZxA1-SUB is placed on a flat and stable surface.

No more than

11.3 kg (25 lb).

No longer than

1.2 m (4 ft).