CLEAR SET-UP AND CONFIGURATION Select amplifier type and activate through "drag and drop." Each amplifier is displayed showing address, operation mode, input level, and network mode (on-line/off-line). Double-click on one amplifier link to the individual control panel for more detail. Amplifiers and channels may be assigned to control groups on customized group control panels with dedicated control parameters.
STATE-OF-THE-ART SIGNAL PROCESSING WITH 24 FILTERS, 5 DELAYS , 2 COMPRESSORS AND 2 LIMITERS Menu control for selection of DSP parameters, speaker assign, impedance monitoring or protocol. Each block of DSP functions shows the amount of active parameters. Filter response, delay times and dynamic settings are displayed as a thumbnail. The DSP functions are: Master-EQ with five filters, each selectable as Low or Hi-Shelf, Low or Hi-Pass, or PEQ. Input-Delay for channel A, B and A+B, up to 1,000 ms.
RANGE OF AMPLIFIERS FOR HIGH AND LOW-IMPEDANCE APPLICATIONS P3000 RL The flagship, with 2 x 1300 watts into 4 ohms and 2 x 1800 watts into 2 ohms, the digital controlled version of the legendary P3000 amplifier. Loudspeaker outputs on Neutrik Speakon® NL4 connectors. P1200 RL The universal with 2 x 600 watts into 4 ohms and 2 x 850 watts into 2 Ohms. Loudspeaker ouputs on barrier strip.
AUDIO PERFORMANCE, REMOTE CONTROL AND SUPERVISION AT THE HIGHEST LEVEL Electro-Voice is famous for its 75 years of experience in designing and manufacturing loudspeakers and microphones. Many audio professionals, however, don’t know that it also has 50 years of design experience in power amplifiers and more than 20 years in digital audio processing.
SMALL SYSTEM CONFIGURATION — HOUSE OF WORSHIP Switch panel (8 switches, 2 per amp) Mixing Console Audio signal Congregation 1 Audio signal 2 RJ-45 CAN GP1 and GP2 bus (in) connectors 3 FRi 152/64 FFRi 152/64 FRi 122/64 RJ-45 CAN bus (out) Audio inputs (from mixer) Lobby 4 FRi 2082 To Amp 2 NOTE: All amps link through CAN bus MEDIUM SYSTEM CONFIGURATION — PERFORMING ARTS CENTER Mixing Console Crestron¤ touch screen FRi122/64 Audio signal Floor Balconies 5 1 Audio signal RJ-45 CAN bus (in) RS
LARGE SYSTEM CONFIGURATION — ARENA Mixing Console PC control station Audio signal UCC-1 converte4Fr Audio signal Main PA Main PA 1 7 2 8 3 9 4 10 5 11 6 12 Audio signal RJ-45 CAN bus (in) Audio inputs (from mixer) RJ-45 CAN bus (out) To Amp 2 NOTE: All amps link through CAN bus ¥ Up to 100 amplifiers per CAN bus ¥ Up to 250 amplifiers per system ¥ Up to 1000m per run ¥ Single run: No loop requirements FRi 122/64 Sky boxes Sky boxes 13 19 14 20 15 21 16 22 17 23 18 24 Sx30
TECHNICAL DATA AND SPECIFICATIONS Network and General Features Maximum Configuration 100 amplifiers per CAN bus over a 1,000 meter cable run, 250 amplifiers in total Supervised Amplifier Parameters Operation mode, temperature, pilot tone, protection mode status, impedance of connected speaker system, output current and output voltage Defective or missing amplifiers, limits, failure protocol Audio Monitoring All input and output signals System Back-Up Last setting stored initiated upon system activati
