User`s manual

29
If you try to perform the “save” or Save As” function and there are unwired
devices, you will see the following warning window. Clicking “Details” will give
you a list of unwired devices:
Figure 38.
You will need to correct these wire problems before you can properly save your
design.
Delay Compensation
QuickBUILD

will calculate and correct any delay alignment discrepancies
between audio paths if you choose for it to do so.
You can tell the software at any time generate delay compensation by choosing
“Delay Compensation” from the “Edit” menu. A

will appear next to “Delay
Compensation” indicating it is turned on.
If you have not selected this and try to save your file, you will see the following
prompt:
Figure 39.