User`s manual

27
DSP Resource Errors
If you have exceeded any of the resources within any or all of the DSP chips, an
error message will appear in the Resource Information box. There are six errors
that can occur. (A listing of these are shown in figure 35.) The error messages
will be located on the lower portion of the box:
Figure 34.
In this case, I have exhausted all resources for DSP 1. The meters obviously
show no resources available, and you can scroll through all six errors using the
up and down arrows (figure 34). As we mentioned in the Monitoring DSP
Resource Meters chapter, the Resource Information box is an estimate of
used and/or remaining DSP resources. Your Information box may not show
any errors when in actuality an error could be occurring. An accurate
accounting of DSP resources can be found in the “QMap Information”
window found in the “Edit” menu. This window will give you detailed
information about all parameters of the QuickMAP you are building. (This window
will be discussed in more detail in the next section.) Here is what the DSP
resource portion of that window looks like:
Figure 35.
If you are approaching low meters in the Resource Information window, check
the QMap Information report to make sure no errors have occurred. If any errors
have happened, you will need to work with your system design to correct them.
This may be as simple as lowering the number of filters in a Filter Tool or moving
a device to a different DSP.