User`s manual

17
After you have selected the desired number of filters, click the “OK” button. You
will then see a series dialog windows relating to each crossover output. They will
look like this:
Figure 16.
You will see one of these dialog windows for every output of the chosen
crossover, if additional filters for that output have been selected. (If no
additional filters have been selected for any or all of the Crossover outputs, you
will be prompted for Crossover output designation when you wire the device.)
This allows you to rename that particular filter device. After you click “OK”, you
will then be prompted to place the device where you want it on the screen.
Figure 17.
When you have finished, your crossover device (in this case a 4-way) should
look something like this (Your wire lines may look different. You can select
different line styles later):
Figure 18.