User`s manual

15
You can always adjust this number at a later time to make your system “fits” in
the given amount of DSP. We will discuss editing these devices next.
1. Editing Filter Tool Parameters
Right mouse click on the Filter device and select “Edit”. You will then see this
dialog window:
Figure 14.
The number of filter bands for each filter device defaults to three. The range of
filters available for each filter is 1 to 10*. To change the number of filters, either
type the value in, or use the up or down arrows to select the number of desired
filters and click the “OK” button. You will then see the DSP Resource meters for
the specified DSP chip adjust accordingly.
The QuickBUILD

software automatically places filter bands in the Y memory of
the DSP. We will discuss selecting X memory in the Advanced Design section.
* 10 filter bands is the largest number that ergonomically fits in a single VUE-IT Filter Tool
window. If you require more than 10 bands at a given point in your design, place two (or more)
filter devices next to each other.