Owner`s manual

Electro-Voice Live X Series Powered Owner’s Manual 11
Amplifier Controls (cont’)
FULL RANGE / WITH SUB
When switched to WITH SUB, activates a 100 Hz highpass for use with a subwoofer.
Always select WITH SUB when using the ELX112P/ELX115P with a subwoofer for
proper acoustic summation.
FULL RANGE EQ
The FULL RANGE EQ switch controls the tone of the loudspeaker. EQ FLAT (–) works
best when the loudspeaker is used for vocal monitors or for speech. EQ MID-CUT ( )
works best for music playback and applications that require enhanced bass and treble.
SUBWOOFER EQ
The SUBWOOFER EQ switch controls the low-frequency extension, or bass boost,
of the subwoofer. EQ FLAT (–) works best when the subwoofer is used under normal
applications. EQ BASS BOOST ( ) provides additional low-frequency extension and
works best for applications requiring enhanced bass performance.
LOUDSPEAKER LEVEL
Level control for adjusting the volume of the loudspeaker. The level control affects the
volume of both INPUT 1 and INPUT 2. LOUDSPEAKER LEVEL control does not affect
the level of the LINK OUTPUT connector.
LIMIT
The LED lights up when the loudspeaker is operated at its limit. Short-term blinking is
uncritical, because the integrated limiter keeps distortion under control. Constant light-
ing of the LED indicates that the sound is negatively affected. Reduce LOUDSPEAKER
LEVEL or INPUT LEVEL knobs to prevent limit.
INPUT SELECT
XLR/TRS 1 allows the signal from XLR/TRS Input 1 to pass to LINK OUTPUT. INPUT
1 LEVEL does not affect the level of LINK OUTPUT. The signal from RCA INPUT is
not passed to LINK OUTPUT. 1+2 is a mix of INPUT 1 and INPUT 2. 1+2 allows the
loudspeaker to act as a basic two-channel mixer that can send the mix to another loud-
speaker via the LINK OUTPUT connector.
LINK OUTPUT
XLR output connector to send the signal to another speaker or subwoofer. The output is
based on the selection made at the INPUT SELECT switch.
LOGO
The EV logo on the front of the loudspeaker lights up when the switch is set to ON.