Owner's Manual

Electro-Voice Tour X Owner’s Manual9
TX-W1 Wheel Kit for TX1181 and TX2181
The TX1181 and TX2181 loudspeakers have six (6) mounting points for the TX-W1 Wheel Kit on their
rear panels. The TX-W1 Wheel Kit is made up of two (2) skid plates with two (2) castors on each skid
plate. When mounted on the rear of a TX1181 or TX2181, they can greatly reduce setup time and
virtually eliminate the need to carry subwoofers.
1. Remove the six (6) screws on the rear of the TX1181 or TX2181 loudspeaker (Figure 13).
2. Align the three (3) holes at the top of the loudspeaker with the three (3) holes of the skid plate. Install
three (3) screws back into the rear of the TX1181 or TX2181 loudspeaker. Repeat this step at the
bottom of the loudspeaker, ensuring all six (6) screws are tight (Figure 14).
Figure 13:
Removing the six (6) Screws from the Rear
of a TX1181 or TX2181 (shown)
Figure 14:
Attaching the TX-W1 and six (6) Screws to the
Rear of a TX1181 or TX2181 (shown)
Wheel Kit
Mounting
Screw
(x6)
TX1181 or TX2181
Loudspeaker
(TX2181 Shown)
Wheel Kit
Mounting
Screw
(x6)
TX1181 or TX2181
Loudspeaker
(TX2181 Shown)
TX-W1 Wheel Kit
(Bottom Skid Plate)
TX-W1
Wheel Kit
(Top Skid
Plate)