User manual

e Electro Industries/GaugeTech Doc # E113-7-07 V1.04 3-14
• If you have typed a wrong password, you will have to type PWCD[Enter] W123 again.
• If you typed the correct password, OK will appear.
NOTE: To change a password, you must disable the password first. Then, enter a new password.
Q
Throughput Mode Password Protection
The passwords set here only protect the GT and PT commands, which are used when the unit needs
to communicate with the slave ports. When this password is enabled, SM1-16 will start in the
command mode after reset or power up.
Throughput Mode Password Protection uses the same sequence as Command Mode above to Enable
and Disable Passwords.
• Type PWTE[Enter]and follow the sequence to enable the password.
• Type PWTD[Enter]and follow the sequence to disable the password.
• Type PW[Enter] to verify the enabled Throughput Mode Password.
3.14: Contact Information for EIG
Electro Industries/GaugeTech
Telephone: [phone]
Fax: [phone]
e-mail: [e-mail]
website: www.electroind.com