User manual

e Electro Industries/GaugeTech Doc # E113-7-07 V1.04 3-13
3.12: Go to Mode Selection
Q
In previous versions, Substation Multiplexor always started in Command Mode. Now, you can
choose Command or Throughput Mode. The advantage of this new feature: When SM1-16 resets
for any reason, it will be in your mode of choice.
• Type GMC[Enter]for Command Mode.
• Type GMT[Enter]for Throughput Mode.
• To confirm this change, Type HU[Enter] (the Unit Status command; see Section 3.8).
3.13: Password Protection
Q
Password Protection is available for Command Mode and Throughput Mode. Each mode is
protected by its own password and each password is independent from the other.
• Type PW[Enter]. The following screen appears:
------------------------------------------------------
PASSWORD PROTECTION
COMMAND MODE : DISABLED
THROUGHPUT MODE : DISABLED
PASSWORD COMMANDS
PWCE : Enable Password for Command Mode
PWCD : Disable Password for Command Mode
PWTE : Enable Password for Throughput Mode
PWTD : Disable Password for Throughput Mode
------------------------------------------------------
Q
Command Mode Password Protection
• Type PWCE[Enter] to enable the password. For this example, 123 will be the password.
• Type W123[Enter] (W<password>[Enter])
• Type W123[Enter] again. OK will appear.
• Type PW[Enter] to verify the enabled Command Mode Password.
Reset the unit or go to Throughput Mode and come back to Command Mode. Type any command; it
will be password protected. Type the password to use all commands.
• Type W123. OK will appear. All commands are available.
Q
Disable Command Mode Password Protection
• Type PWCD[Enter]. Write the password you wish to disable (W123).