User manual

e Electro Industries/GaugeTech Doc # E113-7-07 V1.04 3-12
3.8: Unit Status
Q
Use this command to view a list of all Substation Multiplexor settings.
• Type HU[Enter]. The following screen appears.
------------------------------------------------------
SUBSTATION MULTIPLEXOR
BOOT VERSION : E050
SOFTWARE VERSION : E010
CURRENT CONNECTION : PORT 01
START-UP CONNECTION : PORT 02
START-UP MODE : COMMAND MODE
SITE ID : NA
RESET TIME : NO RESET
------------------------------------------------------
3.9: Site ID
Q
Use the Site ID command to name the location of the Substation Multiplexor. A maximum of 14
characters is allowed.
• Type SIsite_name[Enter], where site_name is a string of up to 14 characters.
• To confirm this change, Type HU[Enter] (the Unit Status command; see Section 3.8).
3.10: Go to Throughput Mode
Q
The GT command puts the Substation Multiplexor in Throughput Mode, allowing the computer to
communicate with the device(s) connected to the selected Multiplexor Slave Port. The Substation
Multiplexor will not accept commands in Throughput Mode. To return to Command Mode send
the escape string detailed in Section 3.5.
• Type GT[Enter]
3.11: Go to Boot Mode
Q
Boot Mode is used for flash upgrading ONLY, as additional features become available. This feature
is reserved for use by EIG technicians, unless you are otherwise authorized.
• Type GB[Enter].