User manual

e Electro Industries/GaugeTech Doc # E113-7-07 V1.04 3-8
3.5: Command Mode
Q
To enter Command Mode from Throughput Mode, send the following escape string:
• [2-second pause]%%%[2-second pause]
• After the last 2-second pause, type H[Enter].
Y Note: This is an actual 2-second pause on either side of the command. The “%” keystrokes must be
made less than two seconds apart.
Q
BE SURE TO USE ALL CAPITAL LETTERS WHEN SENDING COMMANDS TO THE
MULTIPLEXOR; THE UNIT ONLY RECOGNIZES CAPITAL LETTERS.
Q
To begin, type H[Enter]. The following Command Menu appears:
--------------------------------------------
EIG SM Command Mode Commands
H : Display This Menu
HP : Display Port Program Commands
HS : Display Port Status
HU : Display Unit Status
SI : Program Site ID
GT : Go to Throughput Mode
GB : Go to Boot Mode
GM : Go to Mode Selection
PW : Password Protection
EIG : Electro Industries
--------------------------------------------
Q
Commands are listed on the left. Type any command and press Enter. Type H[Enter] at anytime to
access this menu. See the following sections for details about each command.