User manual

e Electro Industries/GaugeTech Doc #: E113-7-07 V1.04 2-5
Q
Use ONLY Channel 1 when setting up configuration. Disregard Channel 2.
Q
Make sure the Baud Rate is 57600.
Q
If you happen to change something in the configuration by mistake, choose 7, Factory Defaults
at the bottom of the screen, reconfigure Channel 1 to have 57600 Baud Rate.
Q
To change the IP Address, choose “0”, Server Configuration and type new IP Address (consult
your Network Administrator for the proper IP Address).
Q
After you have made any and all changes required, choose 9, Save and Exit to save changes
and disconnect from Telnet.
Q
BAUD RATE
The Ethernet Interface and attached serial device (SM1-16) must agree on a speed or baud rate used
for the serial connection. For the Substation Multiplexor, default settings are 57600 baud rate, 8
data, 1 stop, no parity.